Common Gas Furnace Problems and their Solutions

Gas Furnace Problems

Gas furnace use either natural gas or propane for heating the enclosed living areas. Even though the gas is considered as an expensive means of heat, the gas furnaces are preferred over the oil furnaces as they burn cleanly and present their owners with just a few repairs as compared to the oil furnaces. However, when problems arise with gas furnaces, they can be identified easily and also doesn’t cost much. Three common issues which usually arise with the old gas furnaces are briefly described below:

A Furnace which Produces No Heat

Furnace which doesn’t produce heat usually has the following issues:

  • A closed control valve
  • A tripped circuit
  • A blown fuse
  • A defective thermostat
  • A non-functioning pilot light

Even though you can consider repairing these problems by yourself, the best thing is to consult with a professional gas furnace repair service in Abbotsford. A Professional repairing technician would be able to solve your issue on the same day and that too at a very economical cost.

A Furnace which Produces Insufficient Heat

If your furnace is generating insufficient heat, it could be due to the following problems:

  • Blower is occluded
  • Loose blower belt
  • Dirty Filter/burner

All of the above mentioned problems can occur in unison. Just as the furnace which doesn’t produce any heat, a furnace which produces insufficient heat can be fixed on the same day and at a very economical cost. Only an expert gas furnace repairing technician is able to fix your issue in one visit.

Furnace which shuffles between on and off States

If your furnace shuffles between the on and off states before generating the desired amount of heat, it is most likely suffering from the following issues:

  • Clogged Blower
  • Overly dry motor
  • Dirty filter

In the first scenario, a technician will be able to clean out your blower and its surrounding areas using the vacuum, in the second issue, the furnace repair technician in Abbotsford will replace the temporary air filter with the permanent air filter and finally in the third case, he would grease the motor by placing oil in the required ports. In every case, the cost would again be minimal.

So rather than experimenting with the furnace yourself, you can call the furnace repair experts to get the job done in a timely and easy way.

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.